Kobalt SGY-AIR231 Mode D'emploi page 10

ASSEMBLY INSTRUCTIONS
1. Remove plastic air inlet protective cap
from air inlet (E) (See Figure 1).
NOTE: The air inlet (E) will spin freely, so
two wrenches are required to inert the
male plug.
2. Insert the male plug into the air inlet (E).
Using a 3/4 in. (19 mm) wrench
(not included) hold the air inlet nut (E),
and tighten the male plug by turning it
clockwise using a 9/16 in. (14 mm) wrench
(not included) for an air tight connection
(See Figure 2).
DO NOT OVERTIGHTEN.
NOTE: Use threaded sealant tape
(not included) on the threading of the
male plug.
3. Place 2 – 3 drops of air tool oil
(not included) into the opening of the
male air plug before each use
(See Figure 3).
1
2
3
10
E
E