IMPORTANT SAFETY INSTRUCTIONS
Lh
Caution: Read this page
carefully
to
ensure safe operation.
A
WARNING
Before mounting or wiring etc., be sure to remove the wire from the battery ground
terminal. (Not doing so can cause shorts or fires.)
When extending the power supply wire (+ 12 V) or ground wire, make sure to use
automotive-grade wires or other wires with the range of 0.5 mm
2
(AWG 20) to 2 mm
2
(AWG 18) to prevent wire deterioration and damage to the wire
coating.
To prevent a short circuit, never put or leave any metallic objects (such as coins or
metal tools) inside the speaker.
If the product emits smoke or an unusual odor, turn off the power supply immediately
(set it to the standby mode) and stop using it.
After this, please contact your dealer or nearest service station as soon as possible.
This product is for 12 V power supply only.
Do not attempt to open or modify the product, for this could cause fire hazard or
malfunction.
After taking the product out of the polyethylene bag, be sure to dispose of the poly-
ethylene bag out of the reach of children. Otherwise, they may play with the bag,
which
could cause hazard of suffocation.
Do not ingest the
battery,
Chemical Burn
Hazard.
The
remote
control supplied with this product contains a coin/button cell battery.
If the coin/button cell battery is swallowed, it can cause severe internal burns in just
2 hours and can lead to death.
Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and keep
it away from children.
If you think batteries might have been swallowed or placed inside any part of the
body, seek immediate medical attention.
A
CAUTION
Installation
and wiring of the product requires expert skill and experience. To ensure
safety, be sure to have your dealer or specialist perform the installation and wiring.
Do not install
the
product in a spot exposed to excessive heat or humidity.
Do not install the product in unstable
locations
or locations subject to dust.
Do not use gasoline,
naphtha,
or any type of solvent to clean the product. Clean by
wiping with a soft, dry cloth.
•
Connect the speaker wires to appropriate speaker connectors separately. Sharing
the negative
wire of the spe&ker or grounding speaker wires to
the
metal body of the
boat/vehicle can cause this
product
to fail.
When making a
hole
under a seat, inside the trunk, or somewhere else in
the
boat/
vehicle, check that there is nothing hazardous on the opposite side such as a gasoline
tank,
brake
pipe; or wiring harness, and
be
careful not to cause scratches or other
damage.
Do not secure the ground wire to the bolts or nuts of important safety equipment
such as:
Steering or braking devices, airbag mechanisms
(Can cause accidents.)
Fasten the product securely so that it does not get detached due to sudden decelera-
tion and becomes a
hindrance
to driving to ensure that it does not pose a
danger
to
the passengers. (Cause of injury or accidents.)
After installing the product, check that the following electrical equipment are working
properly.
- Lights, navigation lights, brake lights, turn signal lights, windshield wipers, horn
device, etc.
The helmsman or driver must always stop
the
boat or vehicle in a safe location before
performing the next action.
- Remote control operation
Do not use the product for purposes other than on-board mounting.
Keep the volume of sound at an optimum level. Not being able to hear sounds from
outside of your car can lead to traffic accidents.
To prevent damaging the speaker, turn off the power of amplifier before connecting
it to the speaker.