Casanoov HICKER B200 Instructions D'installation page 11

A
Drill 2 holes 10.2 mm in diameter with a spacing of 84 mm between the 2 holes.
Place the 2 slotted hole door support over the drilled holes.
B
C
Place the end motor bracket on the gate bracket by unscrewing the worm screw bolt and screwing it
onto the bracket and tighten it properly.
(Please note that the bolts used to attach the front bracket to the gate are not supplied as the
thickness of each gate is different).
D
Insert the locking pin and clamping washers
E Unlock the motor. Open and close the gate manually to ensure correct operation.
Installation of Motor's Arms to Gates
A
84
10.2
C
B
EN
D
11