Aetertek AT-218C Manuel D'utilisation page 5

Quick Start
Dog switch
Shock button
Vibrate button
Beep
6
Step 6:
Match the receiver and transmitter. First, turn the
transmitter on by pressing the two buttons on the right side of
the transmitter simultaneously until the screen is turned on.
Choose a dog mode (Dog1, dog2 or dog00) by pressing the dog
switch button. For the first receiver, choose dog 1 mode and
quickly press one of the buttons in the front, and the first receiver
will be connected with the transmitter. Meanwhile, the red light
goes off and the blue light starts flashing. If you have another
receiver, turn it on, choose dog 2 mode, press any function
buttons, and the second receiver will be paired. You can train
different dogs separately in different dog systems. If Dog00 is
selected, both dogs will receive correctional signals.
Step 7:
the beep button, the receiver will produce
beeping sound and similarly, push the
vibrate button, it will cause vibration. Cap
the shock test kit on the metal prongs, push
the shock button. If the bulb lights up, the
shock function is ok.
7
-03-
Up button
Down button
button
Check the button function. Push
Tip 3:After 1 minute of inactivity, transmitter will go into sleep mode.
You can wake it up by pressing any function keys.
Tip 4: The duration for pressing the beep, vibrate or shock button will
lead to difference on the length of the beep, vibration or shock time.
Tip 5: When the transmitter is dead or
malfunctioning, use a toothpick or
similar tools to restart the transmitter
by pressing the reset button. Then push both
buttons on the side to turn remote on.
Step 8:
Adjust the intensity of the shock.
There are 2 buttons on the transmitter's right
side: Up button and Down button. The Up
button is to increase while the Down button is
to decrease the intensity of the shock. 10
levels are available. In level 0, you can do
nothing with the transmitter.
Tip 6: To avoid misuse, you can lock the transmitter by pressing the
Up and Down buttons simultaneously. Do it again, and the transmitter
will be unlocked.
Step 9:
Start to train the dogs. Put the collar into the receiver and
wear the receiver around dog's neck. Remember to leave one finger
place between the collar and the neck, and then you can train the dogs.
Reset
Button
DOG
10
0
8