Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION INSTRUCTIONS
INSTALLATION
Place the air conditioner into the window with the
"L" shaped mounting bracket positioned in front of
the upper sash. The bottom of the cabinet should be
positioned on the recessed portion of the window
frame. Pull the upper window sash down until it
rests just behind the front fl ange of the "L" shaped
mounting bracket.
Expand the side curtains on each side and secure
the top of the frames to the window sash using one
13 mm (1/2 inch) screw on each side of the "L"
shaped mounting bracket.
Attach the clamps on the lower part of each curtain
to the window sill using one 13 mm (1/2 inch)
screw on each side of the cabinet.
Place the adhesive foam seal into the opening
between the inside and outside windows and
attached the safety lock to the outside window frame
using two 13 mm (1/2 inch) screws.
Check the Tilt Angle
The air conditioner should be tilted downward
towards the outside approximately 3° to 4°. This
tilt will encourage any condensed water to drain
to the outside. If any condensed water leaks to the
inside of the house, check the tilt angle and adjust
as necessary.
Measure the tilt angle from the front of the cabinet's
edge. The difference in height between the front and
the back of the appliance, labeled "A" on the image
below, should be approximately 19 mm - 2.5 cm
(3/4 inch - 1 inch).
The compressor is located on the left side
of the appliance, on the same side as the
controls. This side of the appliance will be
heavier and more awkward to manipulate.
Inadequate support on the control side of the
appliance can result in personal injury and
damage to the appliance and your property. It
is recommended that you have someone assist
you during the installation of this appliance.
13
CAUTION
A
Publicité
