Caberg JET GHOST X Mode D'emploi page 9

5. Instruction to remove the washable inner lining
5.1 Open completely the whole mask & visor part.
5.2 Unhook the fixing button on the cheek pad. Do the same step on the other
side. (picture_09).
5.3 On both sides, slip off the chin strap from the loops. (picture_10).
5.4 Starting form the neck pad protection, release the inner lining by pulling
slightly towards the inside of the helmet. (picture_11).
5.5 Remove completely the inner lining by pulling down the lining plastic frame
on the front. (picture_12).
INNER LINING CLEANING INSTRUCTION:
HAND WASH ONLY. Scrub by hand with neutral soap and water no hotter than 30°C.
Rinse with cold water. Do not wring. Dry at room temperature.
Never wash the lining in the washing machine.
Never use petrol or other solvents to clean the lining.
6. Instruction to assemble the washable inner lining
6.1 Open completely the whole mask & visor part
6.2 Place the lining inside the helmet
6.3 Slip the chin strap through the cheek pads loops(picture_13).
6.4 Insert he lining plastic strip frame on the front between shell and EPS (picture_
14). Do the same operation for the plastic frame on the neck side(picture_
15) lastly fasten the buttons on the back of the cheek pads.
ENG
9