sunjoe SPX2599-MAX Manuel D'utilisation page 10

5. Turn the water supply tap on completely.
6. Release the safety lock, then press the trigger for a few
seconds until the water flow is steady. Operating the
pressure washer in this manner will allow air to escape
and discharge residual pressure in the hose (Figs. 13 – 14).
Fig. 13
Fig. 14
7. Turn the ON/OFF switch to the ON (I) position to start the
pressure washer (Fig. 15).
Fig. 15
Safety lock
8. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
Using Nozzles
Before beginning any cleaning task, determine the best nozzle
for the job. Each of the nozzles has a different spray pattern.
The nozzle patterns are 40˚ (for gentle cleaning), 15˚ (for tough
jobs), 0˚ (for spot cleaning or hard-to-reach areas), and the
turbo nozzle. The turbo nozzle is a zero-degree rotary nozzle
that spins the spray in a circle so it has a wider cleaning swath.
m
CAUTION!
safety lock on the trigger handle.
Trigger
m
WARNING!
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
This electric pressure washer is equipped with four (4)
Quick-Connect nozzles that easily snap onto the
Quick-Connect collar of the spray wand (Fig. 16).
Fig. 16
10
ON/OFF switch
NEVER change nozzles without locking the
High-pressure jets can be dangerous if