Legamaster PTX-8500UHD Guide Abrégé page 7

5  Troubleshooting
Before calling service personnel, please check the following chart
for a possible cause to the trouble you are experiencing.
 Perform the adjustments according to the instructions on the
„Operating the monitor page"
 If the problem you have experienced isn't described below
or you can't correct the problem, stop using the monitor
and call service personnel or your dealer.
Problem
No Display
The image is not centered
The image is not locked correctly Check the input signal is
The remote control doesn't work Make sure the batteries are new
and installed correctly.
The picture color looks poor
Check these things
Ensure the power plug is
installed correctly at both ends.
Check the main power switch
is set to "—"
Check that source equipment
is operating correctly.
Check the input signal is com-
patible with this display.
Check the input signal is
compatible with this display.
compatible with this display.
Ensure the remote is aimed
at the IR sensor on the front
of the display
Check the picture settings.
Reset the display.
If you are using YUV terminals,
make sure cables are correctly
connected.
6  Compliance and regulatory information
FCC Compliance Statement:
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used
in accordance with the quick setup guide and user manual, may
cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct
the interference at their own expense.
Warning
This is a Class A product. In a domestic environment this product
may cause radio interference in which case the user may be
required to take adequate measures.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC CFR Title 47 Part 15 Subpart B Class A, CISPR 22
ANSI C63.4
ICES-003 Issue 5
EN 55022_EN 61000-3-2_EN-61000-3-3
EN 55024
EN 60950-1 [Low-Voltage Directive (73/23/EEC)]
Information in this document is subject to change without notice.
2015 Legamaster International B.V. All rights reserved.
Reproduction in any manner whatsoever without the written
permission of Legamaster International is strictly forbidden.
Trademarks used in this text: Legamaster and the Legamaster
logo are trademarks of edding AG; Windows is a registered
trademark of Microsoft Corporation, Nextwindow is a registered
trademark of Nextwindow. Mac OS X is a registered trademark of
Apple Inc..
Other trademarks and trade names may be used in this document
to refer to either the entities claiming the marks and names or
their products. Legamaster International disclaims any proprietary
interest in trademarks and trade names other than its own.
7