Vonyx VSP200 Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the backside of the product is indicated on this type of power supply must be connected. Check that the mains voltage
corresponds to this, all other voltages than specified, the device can be irreparably damaged. The product must also be directly
connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
MEDIAPLAYER
1. SD SLOT
You can play media files from a SD card by connecting the device to this slot
2. USB SLOT
You can play media files from a USB device by connecting the device to this slot
3. MODE/LINK
Press to change modes between playing AUX, USB, SD and BT
Press and hold in BT mode to initiate stereo pairing
4. PLAY/PAUSE / REC
Press this button to start/resume or pause play in USB, SD or BT mode
Press and hold to enter recording mode
5. REPEAT
Press to switch repeat modes
6. PREVIOUS / VOL-
Press this button to go to the previous track. Press and hold to decrease the volume level
7. NEXT / VOL+
Press this button to go to the next track. Press and hold to increase the volume level
REAR PANEL
1. MIC 1 VOLUME LEVEL
Controls the microphone 1 volume level
2. MIC 2 / AUX VOLUME LEVEL
Controls the microphone 2 and auxiliary channel volume level
3. MICROPHONE ECHO
Turn to adjust the microphone echo level
4. ECHO ON/OFF
Press to turn the microphone echo effect on/off
5. BASS CONTROL
Adjust the low frequencies
6. TREBLE CONTROL
Adjust the high frequencies
7. MASTER VOLUME
Turn to adjust the master volume level
8. MICROPHONE 1 INPUT
XLR connector for balanced cabled microphone
9. PRIORITY
Press to turn microphone 1 priority on/off. When turned on, the
microphone signal will have priority, meaning that any music level will be
lowered
10. MICROPHONE 2 INPUT
XLR connector for balanced cabled microphone
11. MODE
Press to switch between MIC2 and AUX modes. The chosen mode will be
controllable by knob 2 (MIC 2 / AUX VOLUME LEVEL)
12. AUX IN
Auxiliary 3.5mm input connector
13. PRE OUT
6.3mm jack output to connect with another active speaker
14. WIRELESS UHF A & B VOLUME LEVEL
Turn to adjust the wireless UHF channel A and B volume level
15. WIRELESS UHF ON/OFF SWITCH
Press to turn wireless UHF microphone input ON/OFF
16. INDICATOR LEDs
Clip-, charge- and power indicators
3