Télécharger Imprimer la page

Perel Tools EHS150DC Notice D'emploi page 2

Projecteur halogène + capteur - 150 w

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 5
1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its
lifecycle could harm the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken
to a specialized company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
2.
Safety Instructions
Keep out of reach of children and unauthorized users.
Never look directly into the light, (permanent) eye damage may result.
Be very careful during the installation: touching live wires can cause life-
threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Before opening the housing, remove power from the mains leads by
removing or opening the circuit breaker of the circuit the device is
connected to.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.
• This device falls under protection class I. It is therefore essential that the device be earthed. Have a
qualified person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this
manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if
necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by
the plug only.
• There may be some smoke or a particular smell when the device is activated for the first time. This
is normal and any smoke or smell will gradually disappear.
• Keep the device away from splashing and dripping liquids. Never put objects filled with liquid on top
of the device.
• Do not use the device when damage to housing or cables is noticed. Do not attempt to service the
device yourself but contact an authorised dealer.
• Note that damage caused by user modifications to the device is not covered by the warranty.
00 (23/06/2010)
EHS150DC
User manual
2
Rev. 01

Publicité

loading