Publicité
Warnings
Warnhinweise
Avertissements
Avvertenze
Advertencias
Note:
– Mounting and commissioning is to be conducted by a qualified specialist under compliance with local safety
regulations.
– Do not engage or disengage any connections while under power.
– All mounting surfaces must be clean and free of burrs.
– Avoid direct contact of fluids with the encoder and connector!
– The screws must be tightened with the specified tightening torque according to the Mounting Instructions and
secured against unintentional loosening.
– The tightening torques of the mounting screws are only valid for mounting on steel!
– Scanning unit must first be installed before it is put into operation. Otherwise it could become damaged and
hazardous optical radiation might be emitted.
5
Publicité
