Inserting Batteries In The Remote Control Handset; Operating Range For The Remote Control; Switching The Tv On/Off; To Switch The Tv On - Hoher H22LX810DVD Mode D'emploi

Inserting Batteries in the
Remote Control Handset
• Remove the battery cover located on the back
of the handset by gently pulling backwards
from the indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Place the batteries in the right directions
and replace the battery cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries.
Operating Range for the
Remote Control
• Point the top of the remote control toward the
LCD TV's remote sensor LED while pressing
a button.
Remote range is approximately 7m/23ft.

Switching the TV On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC
50 Hz.
• Press STANDBY switch. Then the standby
LED lights up.
• To switch on the TV from standby mode
either:
• Press the "
button on the remote control.
• Press the -P/CH or P/CH+ button on the TV.
The TV will then switch on.
Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.

To Switch the TV Off

• Press the "
or press the STANDBY switch, so the TV will
switch to standby mode.
• To power down the TV completely, unplug
the power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features
such as Standby Search, Over Air Download or
Timer is active.
English - 17 -
" button, P+ / P- or a numeric
" button on the remote control