Publicité
Les langues disponibles
Les langues disponibles
Interconnections
The SCSI bus allows connection of up to seven peripherals to the host
computer. Use a SCSI cable with a full-pitch connector.
Precautions:
• Switch off the host computer and peripherals before connecting the SCSI
cable.
• Make sure the SCSI connectors are pressed tightly together.
• If this unit is the last (or only) device on the SCSI bus, make sure to connect
a SCSI bus terminator to the open connector.
• The total length of the SCSI cable(s) between the host computer and the last
device should be less than 6 meters.
• Cables and connections must conform to the SCSI-2 specifications. Under
these specifications, the following restrictions apply to bus connections.
Connections must be single-ended, and must have an impedance of 90 to
132 ohms.
Distance between adjacent devices should be at least 30 cm.
Branches in the bus are not allowed.
*1
When using high-speed data transfer with the TSL-S9000L, total length
of the SCSI cable should not exceed 3 meters.
SCSI cable
*1
Terminator
Interconnections
Chapter 2 Preparation
AC power
13
Publicité
