Alto Professional Presenter PA Guide D'utilisation page 6

Operation
To power Presenter PA on or off, use the power switch.
To play audio from an auxiliary device:
1. Connect an audio device to the aux input using a stereo 1/8" (3.5 mm) cable.
2. Power on Presenter PA.
3. Play audio on your device, and turn the Aux/Bluetooth Volume knob to adjust the output
volume level. Also, adjust the volume level on your device.
To play audio from a Bluetooth device:
1. Turn on your Bluetooth device.
2. Power on Presenter PA. If you have previously connected to another Bluetooth device,
Presenter PA will reconnect. To disconnect pairing if the Bluetooth LED is lit solid, press
and release the Bluetooth Pair button.
3. Navigate to your Bluetooth device's setup screen, find Presenter PA and connect.
4. Play audio on your device, and turn the Aux/Bluetooth Volume knob to adjust the output
volume level. Also, adjust the volume level on your device.
To use a microphone with Presenter PA:
1. Make sure the microphone is connected properly to the XLR input above the top panel tray
on the right side.
Note: Only dynamic microphones are supported.
2. Speak into the microphone and adjust its position, if necessary.
To adjust the microphone volume, turn the Mic Volume knob.
To mute the microphone, press and hold the Mute button next to the XLR input.
To unmute the microphone, release the Mute button.
To use a podium lamp (not included), make sure it is connected properly to the 4-pin input
above the top panel tray on the left side. The podium lamp will turn on automatically. Adjust
the position of the lamp if necessary.
To charge a device, connect it to the USB port on the rear panel.
Important: Presenter PA must be powered on to charge a connected device.
6