Indel B SW CUBE 24 V Instructions D'utilisation page 31

6.3 - ELECTRICAL CONNECTIONS
"CUBE"'s electrical connection is relatively simple; however, when in doubt, please contact the INDEL-B
assistance staff or an authorised workshop.
There are three methods for performing the power connections:
- through the utility power outlet, usually used for the coffee machine, kettles, etc (normally an option for the
vehicle); if it is present, make sure that the power is suitable for absorption and, in any case >22A.
- through power and grounding points which in most vehicles are located in the cabin (normally behind the
dashboard on the passenger's side in the relay and fuse section); this solution allows to always be able to use
"CUBE"'s power source.
- directly to the vehicle's battery; the advantages of this solutions lie in the fact that it is not necessary to
disassemble any component inside the cabin, but there will be an extension lead which will have to feed "CUBE"
in the cabin.
In case "CUBE" must be moved from one vehicle to another it is possible, regarding the electrical connections, to
use a bridle (G.1) so as to not have to remove the one connected to the first vehicle. For this purpose, contact
INDEL-B.
Method for connection to the utility power outlet:
WARNING: if there is a power outlet, make sure
that the power is suitable for absorption and,
in any case >22A.
The outlet's counterpart is not supplied with
"CUBE" (refer to the vehicle manufacturer's
assistance service).
Cut and remove the eyelets at the tips of the
1
bridle's red and black wires (G.1).
Connect the purchased counterpart to the bridle's
2 red and black wires (G.1) in place of the removed
eyelets.
Connect the bridle's (G.1) counterpart to the
2
power outlet.
Connect the power lead (G.2) to the bridle (G.1)
4
and to "CUBE".
29