KW Hydraulik STANLEY DUBUIS BPE062 Manuel D'utilisation page 13

USING THE TOOL
Select the dies set. Insert the dies into the
crimping head (ball headed dowel).
Put the connector with the cable inserted be-tween the two dies.
CHECK THAT THE LOCK IS CLOSED CORRECTLY BEFORE CRIMPING
Press the crimping trigger up to automatic return of the mobile die.
Release the trigger. The motor stop.
CAUTION: THE DIES TIGHTEN VERY TIGHTLY. DO NOT SLIDE YOUR FINGERS IN THE
DIES PROFILE.
If necessary, press the emergency release
trigger.
PERFORM OTHER CRIMPINGS IN THE SAME WAY.
To remove the dies, open the head and then remove the dies.
0215 - BPE062 - 13
Slide the battery all the way into the
tool until lock clicks.
Open the head to remove
the crimping connector.
English