König Electronic KN-MICW510 Mode D'emploi page 4

Operation:
1. Connect the 6.3mm microphone cable to a mixer or amplifi er.
2. Connect the AC/DC adapter to the receiver and a wall outlet. The
receiver switches on automatically.
3. Pull out the antenna to its maximum size.
4. Open the battery cover and place two AA batteries (not supplied)
5. Turn on the microphone with the ON/OFF switch.
6. The system is ready for use.
Specifi cations:
Receiver:
Frequency Range
Frequency Stability
S/N Ratio
Image and Spurious Rejection
Receiving Sensitivity
Selectivity
Dynamic Range
Modulation Mode
IF Frequency
AF Response
T.H.D.
Audio Output
Power Supply
Microphone:
Frequency Range
RF Power Output
Frequency Stability
Maximum Deviation
T.H.D.
Microphone Capsule
Operating voltage
Current consumption
VHF 198.600MHz
± 0.005% with quartz-locked control
> 94dB, at RF=1mV
80 dB minimum.
at 10 dBμV over 80 dB S/N ratio.
>50dB
>96dB
FM.
10.7MHz
80Hz~12KHz (±3dB)
<1% (at 1KHz)
Unbalanced output
DC 12V
VHF 198.600MHz
10mW (max.)
± 0.005% with quartz-locked control
± 15KHz
<1% (at 1KHz)
Uni-directional dynamic
2 x 1.5V AA size batteries
35mA ± 5mA at 2.4V
4