Troubleshooting; Error Prompt; When Measuring - Welch Allyn RPM-Scale100 Mode D'emploi

Directions for use

Troubleshooting

This section includes a list of error messages and frequently asked questions for
problems you may encounter with your weight scale. If the device is not operating as
you think it should, check here before arranging for servicing.

Error prompt

Error
Dotted lines
Error condition

When measuring

Problem
No display on the LCD screen with the
scale powers on
The scale powers off automatically
Description
Overload. The device will power off
Low Battery. The device will power off
in four seconds.
At any point, when a situation occurs
that prevents a successful test
acquisition, an error code will be
displayed in the LCD area. The
message will persist for several
seconds until the device times out and
powers down.
Root cause
Batteries are not installed or not
installed properly
Worn batteries
Low Battery.
Use the scale A-9
Solution
Stop using this scale for measurement
Replace all four batteries at the same
time. Purchase the authorized batteries
for replacement.
Check the following items:
• Bluetooth wireless technology is
on.
• The application is on.
• Both devices are within the
transmission distance of
Bluetooth devices.
Solution
Install the batteries. Go to "Insert or
replace the batteries"
Replace all four batteries at the same
time. Purchase the authorized batteries
for replacement.
Replace all four batteries at the same
time. Purchase the authorized batteries
for replacement.