Vonyx 170.368 Manuel D'instructions page 5

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWER SUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REAR PANEL
1. MICROPHONE/LINE VOLUME LEVEL
Controls the microphone/line input volume
2. MP3 VOLUME LEVEL
Controls the MP3 input volume
3. TREBLE
Adjust the high frequencies of the corresponding
channel
4. BASS
Adjust the low frequencies of the corresponding channel
5. LINE/MICROPHONE SWITCH
Press to switch between line- and microphone input
6. XLR LINE/MICROPHONE INPUT
XLR connector for line/microphone signal input
7. XLR MIX OUTPUT
XLR connector for mix signal output
8. AC IN AND FUSE HOLDER
Socket for plugging in the supplied power cord. For instructions
on how to change the fuse, see "REPLACING THE FUSE"
9. POWER SWITCH
Turn the device ON or OFF
MEDIAPLAYER
1. USB SLOT
You can play media files from a USB device by connecting the device to this slot
2. DISPLAY
The display shows multiple forms of information, for example current MODE, elapsed time, etc
3. MODE BUTTON
Press to change modes between playing USB, MP3 and BT
4. PLAY/PAUSE BUTTON
Press this button to start or pause play
5. FOLDER BUTTON
Press this button to enter FOLDER selection
6. PREVIOUS BUTTON
Press this button to go to the previous track. Press and hold to scan backwards within tracks
7. NEXT BUTTON
Press this button to go to the next track
Press and hold to scan forwards within tracks
5