Batavia FIXXPACK 12V BT-CAG003 Mode D'emploi page 10

English
The machine must always work against the
direction of the cut; so never move the
machine in the other direction! There is the risk
that the machine will catch in the cut causing
kickback and that you will lose control.
Hints for optimum use
• Clamp the work piece. Use a clamping
device for small work pieces.
• Hold the machine with both hands.
• Switch on the machine.
• Wait until the machine has reached full
speed.
• Place the wheel disc on the work piece.
• Slowly move the machine along the work
piece, firmly pressing the wheel disc
against the work piece.
• Do not apply too much pressure on the
machine. Let the machine do the work.
• Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.
MAINTENANCE AND CLEANING
WARNING: Always disconnect from the mains
power supply, before carrying out any mainte-
nance/ cleaning of the charger. Remove the
battery before carrying out any maintenance/
cleaning of the tool.
Maintenance
There are no inner parts of the tool which need
maintenance.
Cleaning
• Keep safety devices, ventilation openings
and the motor housing as free as possible
from dirt and dust. Rub the electric power
tool with a clean cloth or blow over it with
low pressure compressed air.
• We recommend that you clean your elec-
tric power tool immediately after each use.
• Clean the electric power tool regularly with
a damp cloth and somewhat soft soap. Do
not use any cleaning or solvent materials;
these can attack the device's plastic com-
ponents. Make sure that no water can get
inside the electric power tool.
8
TECHNICAL DATA
Speed . . . . . . . . . . . 12000
Grinding disc diameter . . . . . . . . Ø 76 mm
Drive shaft thread. . . . . . . . . . . . . . M5
Weight . . . . . . . . . . . . . . . . . 0.68 kg
Sound Pressure Level L
Uncertainty K . . . . . . . . . . . . . . 3 dB
pA
Sound Power Level L
WA
Uncertainty K . . . . . . . . . . . . . . 3 dB
WA
Hand Arm Vibration. . . . . . . . . 0.732 m/s
Uncertainty K . . . . . . . . . . . . . 1.5 m/s
DISPOSAL
Do not dispose of electric power
tools with domestic refuse.
The electric power tool is shipped in
packaging to reduce transport damage. This
packaging is a raw material and as such can
either be reused or can be fed back into the
raw material cycle. The electric power tool and
its accessories are made from various materi-
als such as metals and plastics. Take defective
components to a special refuse collection
point. Ask about these at your specialist shop
or local council. The product and the user
manual may be subject to changes. Technical
data may be changed without prior notice.
Batteries
Think of the environment when disposing of
batteries. Contact your local authorities to find
out where your nearest disposal area is. Do
not dispose of batteries with domestic refuse.
Do not dispose of by burning, risk of explosion.
9500 min
-1
. . . . . 75.6 dB(A)
pA
. . . . . . 85.6 dB(A)
-1
2
2