Steba WK 31 THERMO Mode D'emploi page 13

Getting started
∙ Unwind the cable from the cable storage und plug it in.
∙ Open the lid with a slight anti-clockwise twist and remove it, fill the device with
water and close the lid.
∙
Do not fill the above the maximum marking on the water gauge because
hot water can escape.
∙ Place the container onto the base, the device beeps 2 times and 100°C flashes.
∙ Press the ON/OFF button.
∙ The device starts with the 100°C mode and starts heating. During the heating pro-
cess, the current temperature is shown on the display. Once the temperature is
reached, the device beeps twice and turns into standby mode.
∙ Setting the temperature:
o Choose the desired temperature 40, 50, 60, 70, 80, 90°C with the selection
button.
o Press the ON/OFF button, the device starts heating.
o Once the temperature is reached the device beeps twice and turn into
standy mode.
Troubleshooting
Dear Client,
Thank you for buying this STEBA product. The following table will help you with pro-
blems that may occur when using your device. For many problems there is a simple
solution, because not everything that appears like a malfunction must be serious.
Please check the following list before contacting our customer service.
Problem
Control light does
not shine once de-
vice is plugged in
Boiling result is bad
Device turns off
Reason
∙ No power
∙ To many devices at one
power cord
∙ Lid is not closed properly
∙ Heating plate is calcified
∙ Due to scale, heat accumu-
lates and triggers the mi-
croswitch
Solution
∙ Check is plug is plugged-in
correctly
∙ Check the fuse
∙ Close the lid
∙ Decalcify the device
∙ Leave to cool for 10 min-
utes.
∙ Descale
13