PNI CA500 Manuel Utilisateur page 2

Relay with remote controls PNI CA500
Technical specifications:
• Sensitivity: -105 dBm
• Communication frequency with the remote control: 433 MHz
• Transmisision power: 10 mW
• Power supply: 12V DC
• Channels: 2
• Output current: ≤10 mA
• Operating mode: self-closing (relay not energized COM-NO-NC)
• Operating temperature: -26°C ~ +80°C
• Compatible with remote controls with chipset: PT2262, SC2260, EV1527
• Remote control power supply: alkaline battery type 23A 12V (included)
NO1: GND VSS AC/N
COM: +12V VDD/AC
NC1: GND ON/OFF
NO2: GND VSS AC/N
COM: +12V VDD/AC
NC2: GND ON/OFF
Operating modes:
1 2
1. Manual mode - press the A/B button on the remote control. The door remains open until you press the button
again (the doors work independently).
2. Self-closing mode - press and hold the A/B button to open the door. When you lift your hand from the button,
the relay returns to its initial state (the doors operate independently).
3. Dual mode - this mode can only be used if you have connected 2 different doors (A and B) to the available relays
and it works like this: press button A to open door A, when you press button B, door A will close and the door B
will open and will remain open until you open door A or the voltage is removed. In this way, the relays / doors are
dependent on each other.
Operating mode selection
• Turn off the power to the relay
• Place the jumper in the position corresponding to the desired operating mode (1, 2 or 3)
• Re-energize the relay.
Learning a remote control
• Briefly press the learning button. The LED lights up.
• Press the A button on the remote control. The red LED flashes 3 times then stays on to confirm the learning
of button A for the command of the first relay. The red LED stays on.
• Press the B button on the remote control. The red LED flashes 3 times then turns off to confirm learning.
• Repeat the procedure for learning additional remote controls.
Erasing remote controls
• Press the learning button until the LED goes out.
• Release the button. The LED will flash 3 times to confirm the deletion of all remote controls.
+12V
GND
Operating mode
Learn button
selection jumper
3
User manual - 2
LED indicator
State LED
A button
B button