Publicité
Les langues disponibles
Les langues disponibles
DISPLAY
Press DISPLAY to display the current information on
the screen.
When the TV receives a digital signal, the digital
information will appear.
62-1 HDTV_Moving_Picture...
CH-1
TV-MA
Digital
Air
No Program Information is available
Full
1080i
•
Channel number
•
Channel label (if preset)
•
V-Chip rating
•
Sleep timer
•
Program guide
•
Resolution
When the TV receives an analog signal, the analog
information will appear.
14
G
Analog Cable
Mono
Full
480i
•
Channel number
•
V-Chip rating
•
Sleep timer
•
Audio information
(Stereo, SAP or Mono)
Press DISPLAY again to clear the call display.
NOTE:
•
After a few seconds, DISPLAY screen will return to
normal TV operation automatically.
RECALL
This button allows you to go back to the last channel
selected by pressing RECALL. Press RECALL again to
return to the last channel you were watching.
MUTING
Press MUTING to switch off the sound. The TV's
sound will be silenced and "Muting" will appear on
the screen. The sound can be switched back on by
pressing this button again or the VOL + or –.
SLEEP
To set the TV to turn off after a preset amount of time,
press SLEEP on the remote control. The clock will
count up 10 minutes for each press of the SLEEP
button (Off, 0h 10m, 0h 20m, ..., 2h 0m). After the
sleep time is programmed, the display will appear
briefly every ten minutes to remind you that the sleep
timer is operating. To confirm the sleep timer setting,
press SLEEP and the remaining time will be displayed
for a few seconds. To cancel the sleep timer, press
SLEEP repeatedly until the display turns to Off.
EN 16
Sleep Timer
Off
English
•
Station name
•
Broadcast program name
•
Signal type
•
Audio language
•
Picture size
Sleep Timer
Off
•
Channel label (if preset)
•
Signal type
•
Picture size
•
Resolution
Quick guide for menu
operation
Call menu and for example: Select Language.
1
Press INPUT SELECT to select TV mode.
2
Press TV MENU. The TV menu screen will appear.
Main Menu
>>
Picture
Audio
Channel
CH
Lock
Setup
3
:Select
ENTER :Set
Press ▲ or ▼ to select "Setup", then press ▶ or
ENTER.
4
Press ▲ or ▼ to select "Language", then press ◀
or ▶ to select the desired language.
...on the following pages the menu can be called
in the same way as here.
5
Press EXIT/CANCEL to return to the normal
screen.
NOTE:
•
If no buttons are pressed for more than about 60
seconds, the menu screen will return to normal
operation automatically.
Publicité
