MAXXTER ACT-IPC-01 Manuel page 21

ACT-IPC-01
ROTATING HD WIFI CAMERA
FAQ
Q: How to restore the factory default settings?
A: There is one small hole at the bottom of the camera. Press the small reset
button inside with until you hear a sound like "drawing a sword". This sound
means that the reset was successful.
Q: Failure when adding devices
A: Please check that if the camera and the phone are in the same LAN.
If the camera and the phone aren't in the same LAN, users should use ID
number to manually add the camera.
Q: When trying to watch camera live feed, is says password is wrong.
A: Please check if the remote access password is right or not, the password
set up when adding the camera. If it is wrong, please select "edit" in the
entry list of the camera and set up a remote access password again.
If you forget the remote access password of the camera, you can press
"Reset" and the device will restore the factory default setting. When you add
the camera in the first time, you need to set up a new password. Otherwise,
you cannot continue the remote access.
Q: It shows that devices offline in the devices list.
A: Please check that if camera is connected to the internet.
21
All brands and logos are registered trademarks of their respective owners