Télécharger Imprimer la page

LOGICOM L-240 Manuel D'utilisation page 29

Publicité

Les langues disponibles

Les langues disponibles

Dispose of used batteries according to the instructions.
Charging the battery:
• To charge the battery, connect the USB cable (supplied) to the USB port of
your Feature phone and the other end to the mains adaptor (supplied). Then
connect the mains adaptor to a power outlet.
• The battery charge icon illuminates during charging and indicates the charge
status.
• When the battery is fully charged, you can disconnect the USB cable from the
device then from the power outlet.
IMPORTANT:
• The Feature phone is only recharged via its USB port.
• Ensure your Feature phone is fully discharged before charging it for the first
time.
• The battery must be charged for at least 5 to 8 hours when first charged.
• After a long period without use, It should be necessary to do many cycles of
charging / discharging to obtain maximum power capacity
Note: You can use the device when it is being charged. In this case, the battery
may take longer to charge fully.
Safety information for charging the battery:
• To recharge the battery, only use the mains adaptor supplied with your device.
Do not use any other power supply or electrical device.
• The power outlet to which the device is connected must be near the
equipment and must always be easily accessible.
• Always wait at least 5 seconds after switching off the device before restarting
it. Switching the device off and then back on again immediately may damage
the electrical circuits.
• Do not disassemble, open or shred the battery contents. Do not dispose of
batteries in fire or water. Do not charge the battery if the room temperature
exceeds 45° C. Keep the battery in a clean and dry place. Avoid leaving the
battery under sunlight.
29

Publicité

loading