Veho ZB-7 Mode D'emploi page 8

Reset Ensure the headphones are disconnected from
devices. Simultaneously press and hold the power and
volume - buttons for 5 seconds.
Answering/ending calls Press the power button once to
answer an incoming call. Press once again to end the
call.
Rejecting calls Press and hold the power button for 2
seconds to reject an incoming call.
Call mute/unmute Press and hold the volume +
button for 3 seconds.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a
residential installation. This equipment generates uses and
can radiate radio
frequency energy and, if not installed and used in
16
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
VEP-024-ZB7-B_Manual (80 x 80).indd 16-17 VEP-024-ZB7-B_Manual (80 x 80).indd 16-17
installation. If this equipment does cause harmful
Call switch Simultaneously press and hold the volume
+ and volume - buttons for 2 seconds during a call to
switch between the headphones and mobile device.
Number redial Double click the power button to redial the
most recent contact on your call log.
EN
17
14/02/2023 16:02 14/02/2023 16:02