Kopp 3238.0009.3 Mode D'emploi page 4


Operation Instruction
1. Remove cover
2. Insert battery (9 V alkaline, not included). Observe
polarity. Don't damage the wires. Replace the cover.
3. Turn on the set with blue adjusting wheel
4. The LED indicator (small red light) will immediately
light steadily. Make sure that no metal parts or vol
tage carrying parts are nearby. Turn the wheel until
the indicator light goes off. Now the set is ready for
use.
5. If the light indicator doesn't go on - or won't go out
- after the set has been switched on, the set can be
adjusted from the inside. To do this, adjust the blue
wheel (after switched on) by 1/2 turn and turn the
potentiometer in the middle of the set with a small
screwdriver (orpaper clip) slowly, until the indicator
light goesoff or on. If the LED pulses continuously
(with no voltage carrying object nearby) adjust the
potentiometer farthest from the battery counterclo
ck-wise until the LED just stops pulsing. Then test to
make sure the LED will pulse when the set is held
about 2" to 3" away from a known A.C. voltage
source as shown in Step 6. Adjust the potentiometer
additionally if necessary.
6. Hold the detector as shown in the picture and move
it along the wall. Bigger metal parts (conduits, water
pipes) will be indicated up to a distance of
3- 1/2" (9 cm). The LED will light steadly and buzzer
beeps while metal is being detected.
7. A.C. voltage carrying parts (not shielded conductors
or those within metal conduit or pipe) will be shown,
with a banking light and buzzer beeps. The indicator
will light up from a greater distance if power is
running.
8. To turn the detector off (don't forget) turn the blue
adjusting wheel toward the light, until the turn-off
switch is engaged.
9. Only in accordance with installation rules! Subject to
all technical alterations.
4