Publicité
Les langues disponibles
Les langues disponibles
COMPONENT 1/4"
Outside Blade
1
Outside Blade
1
1/16" Chipper
-
1/8" Chipper
-
Blade Shims
2
DADO SETUP INSTRUCTIONS
• Use the Dado Cut Chart (above) to select the
components needed for the dado width that you
want and proceed with the following.
• Unplug the saw and remove the nut, outer flange,
and saw blade from the arbor shaft.
• Carefully clean and inspect the arbor shaft threads,
nuts, flanges, dado pieces, and all safety devices.
• Determine the proper rotation of the outside saws
and chippers (the face of the teeth should be facing
the front of the table saw if using a table saw).
• Place the inside flange on the arbor shaft (if not
already attached) and install the left outside saw
blade with the high point of the angled teeth on the
outside of the cut and the blade markings facing
out.
• As needed, add the desired number of chippers,
spacers, and shims (be sure to place the chipper
teeth inside the gullet area of the outside blades and
space the teeth so they do not touch. If using more
than one chipper, space them evenly for optimum
balance and cutting performance.
5/16" 3/8"
7/16" 1/2"
1
1
1
1
1
-
-
1
2
2
TOLL FREE:1-800-705-4454 • FAX:905-326-5451• TEL:905-326-5450 • E-MAIL: INFO@TOOLWAY.COM
CUTTING WIDTH
9/16" 5/8"
1
1
1
1
1
1
1
-
1
1
2
2
2
2
2
• If using spacers, only install one spacer in between
each pair of chippers or between an outside blade
and chipper. If using multiple shims, spread them
evenly throughout the stack.
• Add the right outside saw blade and make sure that
the chipper teeth (or left outside blade teeth) are
inside of the gullet area of the right outside saw
blade. It is important that no carbide teeth are in
contact with each other or another part of the blade
body prior to tightening.
• Install the outer flange and tighten the nut. The
nut should be secured by a minimum of 3 threads
on the arbor shaft. If you are cutting a wide dado
width, you may need to leave the outside flange off
of the arbor shaft to ensure that the nut is securely
fastened by at least 3 threads.
• Make sure all safety guards are in place and
re-install table saw dado insert if using a table saw.
• Plug in the saw and perform a test cut in scrap
wood to ensure you have the desired cut width.
• Adjust the cut width with shims as necessary.
11/16" 3/4"
1
1
1
1
1
1
-
1
-
3
3
4
2
2
2
ENGLISH
13/16"
1
1
1
4
2
4
Publicité
