Publicité
EN/F/E
It is important to read this user manual prior to using your new product for the fi rst time.
Nous vous recommandons de lire ce manuel d'instructions avant d'utiliser votre nouveau produit pour la première fois.
Es importante leer este manual antes de usar por vez primera su equipo.
Before you begin
Plugging in for power
•
Connect the power cord to a convenient wall outlet.
•
Once connected with power, the clock fl ashes. Refer to
the Clock section for instructions on properly setting the
Clock.
Battery back-up operation
•
This clock is equipped with a timekeeping system that
can be powered with a 9-volt alkaline battery (not
included). The power failure protection circuit will not
operate unless battery is installed.
•
When normal household power is interrupted, the
battery will power the clock to keep track of time and
alarm settings programmed into memory.
•
When the battery backup functions, the digital display
will not light, however, the function of alarm still occurs
during the power interruption if remaining battery
power is adequate.
•
Normal operation will resume after AC power is
restored so you will not have to reset the time or the
alarm.
To install the battery:
1. Remove battery compartment door (located at the
of the clock) by applying thumb pressure to the tab
on battery door and then lift the door out and off the
cabinet.
Battery
compartment
2. Connect a 9-volt alkaline battery (not included) to the
connector plug.
3. Replace the compartment door.
Warranty information
INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER
WARRANTY. No person or representative is authorized to
assume for the Company any liability other than expressed
herein in connection with the sale of this product.
Some states do not allow limitations on how long an implied
warranty lasts or the exclusion or limitation of incidental or
consequential damage so the above limitations or exclusions
may not apply to you. This Warranty gives you specifi c legal
rights and you may also have other rights which vary from
Power failure indicator
If you have not installed the
9-volt alkaline battery
product, or the
battery
runs out while
power is
all the settings (clock and alarm) will be lost. After AC power
is restored, the Digital Display will fl ash to indicate that
power was interrupted and you should readjust the time
settings.
Note: It is recommended to replace the
battery
per year even if no power failures have occurred.
Alkaline (NEDA 1604A/IEC 6LR61)
type
battery is recommended. Carbon-zinc battery
may be used but memory holding time will
be substantially reduced. Memory holding
time for a fresh alkaline battery is approximately 8
hours (if alarm is not operated) which should take
care of short, nuisance-type AC power failures. To
preserve battery life, the unit should remain plugged
into an AC outlet. As the battery gets older, its
voltage drops and memory may be lost. Be sure to
replace the battery periodically. Battery should be
removed if the unit will be stored for more than one
back
month.
A leaky battery
can badly damage unit.
Français
•
Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
•
Only use attachments/accessories specifi ed by the
manufacturer.
•
Use only with the cart, stand,
tripod, bracket, or table specifi ed
by the manufacturer, or sold with
the apparatus. When a cart is
used, use caution when moving
the cart/apparatus combination to
avoid injury from tip-over.
General controls
Top view
in the
interrupted,
at least once
HR – Adjust hour in clock setting mode or alarm setting
mode
MIN – Adjust minute in clock setting mode or alarm
setting mode
SNOOZE – Enter snooze mode where the alarm will quiet
but sound again once the snooze period is over
Back view
ALARM ON/OFF – Turn the alarm on/off
DIMMER LOW/HIGH – Adjust the brightness of the display
TIME SET/ALARM SET – Enter clock setting mode or
alarm setting mode
IMPORTANTES INSTRUCTIONS DE SECURITE
BIEN LIRE ET CONSERVER POUR RÉFÉRENCE ULTÉRIEURE
renversement.
•
Débranchez l'appareil pendant les orages ou si vous ne
l'utilisez pas pendant de longues périodes.
•
Confi ez l'entretien à du personnel compétent.
Les réparations sont nécessaires si l'appareil a été
endommagé de quelque façon que ce soit, comme un
cordon d'alimentation ou une fi che en mauvais état,
si un liquide a été renversé sur l'appareil, si des objets
sont tombés sur l'appareil, si l'appareil a été exposé à
l'eau ou à l'humidité, si l'appareil ne fonctionne pas
•
No naked fl ame sources, such as lighted candled, should
be placed on the apparatus.
•
Attention should be drawn to the environmental aspects
of battery disposal.
•
The use of apparatus in moderate climates.
CAUTION: TO PREVENT ELECTRIC SHOCK DO NOT USE THIS
]
(POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE
OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY
INSERTED TO PREVENT BLADE EXPOSURE.
Portable Cart Warning
Clock
Setting clock manually
1. Slide the TIME SET/ALARM SET switch to the TIME
SET position to enter clock setting mode.
2. Press HR to set the hour.
•
The clock is in 12 hour format. The PM indicator will
appear for showing a PM time.
3. Press MIN to set the minute.
4. Slide the TIME SET/ALARM SET switch to the LOCK
position to confi rm and exit clock setting mode.
Alarm
Setting alarm time
1. Slide the TIME SET/ALARM SET switch to the ALARM
SET position to enter alarm setting mode.
2. Press HR to set the hour.
•
The clock is in 12 hour format. The PM indicator will
appear for showing a PM time.
3. Press MIN to set the minute.
4. Slide the TIME SET/ALARM SET switch to the LOCK
position to confi rm and exit alarm setting mode.
Turning on/off the alarm
1. Slide the ALARM ON/OFF switch to the ON position.
The AL indicator will turn on to show that the alarm is
on.
2. Slide the ALARM ON/OFF switch to the OFF position.
The AL indicator will turn off to show that the alarm is
off.
Ways to turn off alarm
•
To silence the wake function momentarily, press
SNOOZE. The alarm will be on again when the snooze
period (9 minutes) is over.
•
To disable the wake function completely, slide the
ALARM ON/OFF switch to the OFF position. The AL
indicator will turn off to show that the alarm is off.
Light
Slide the DIMMER LOW/HIGH to adjust the brightness of
the display.
Branchement
ALIMENTATION COURANT ALTERNATIF : 120 V ~ 60 Hz
La prise de l'appareil est polarisée (une des
fi ches est plus large que l'autre) et ne peut
s'enclencher que d'une seule façon dans
une prise de courant alternatif. Si la prise
n'est pas complètement insérée dans la prise
murale, retournez la prise et essayez de
l'insérer dans l'autre sens. Si elle ne rentre
or th
Eco
Help
disp
desi
W
12 M
App
AUD
to t
this
cond
with
defe
prod
and
To o
War
war
defe
add
This
exte
prob
to c
prod
or o
or t
card
othe
syst
This
whi
bee
mish
defa
THE
WA
PRO
COM
PUR
This
liab
IMP
LIM
ANY
INCL
MUS
FRO
THE
Av
Bra
• Br
ap
• Lo
Co
su
Ali
• Ce
Publicité
