Publicité
Les langues disponibles
Les langues disponibles
• NIOSH/OSHA/MSHA respiratory protection.
WARNING
and other construction activities contains chemicals known to the State of California
to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding,
drilling, and other construction activities. Wear protective clothing and
wash exposed areas with soap and water. Allowing dust to get into your
mouth, eyes, or lay on the skin may promote absorption of harmful chemicals.
WARNING
Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from
face and body.
WARNING
Always wear proper personal hearing protection that conforms
to ANSI S12.6 (S3.19) during use. Under some conditions and duration of use, noise
from this product may contribute to hearing loss.
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ................... volts
Hz ................. hertz
min ............... minutes
or DC ... direct current
................. Class I Construction
..................... (grounded)
................. Class II Construction n o ....................no load
(double insulated)
.../min .......... per minute
BPM ............. beats per minute
IPM ............... impacts per minute
RPM ............. revolutions per
minute
sfpm ............. surface feet per minute
MOTOR
Be sure your power supply agrees with the nameplate marking. Voltage decrease of
more than 10% will cause loss of power and overheating. PORTER-CABLE tools are
factory tested; if this tool does not operate, check power supply.
NOTICE:
within correct limits. Do not operate tools rated A.C. only on D.C. current. To do so
may seriously damage the tool.
Some dust created by power sanding, sawing, grinding, drilling,
SAVE THESE INSTRUCTIONS
Do not operate your tool on a current on which the voltage is not
A ......................amperes
W .....................watts
or AC ..........alternating
current
or AC/DC ...alternating or
direct current
speed
n ......................rated speed
.....................earthing
terminal
.....................safety alert
symbol
6 - ENG
Publicité
