Publicité
Les langues disponibles
Les langues disponibles
SHAPING THE OUTSIDE EDGE OF A PIECE OF STOCK
1.
Shape the end grain, left to right
2.
Shape the straight grain side moving left to right
3.
Cut the other end grain side
4.
Finish the remaining straight grain edge
NOTE: Make several light passes instead of one heavy pass for better quality work.
VARIABLE SPEED CONTROL (FIG. 8) (PCE6435 ONLY)
This laminate trimmer is equipped with a variable
speed dial (T) with an infinite number of speeds
between 16,000 and 30,000 RPM. Adjust the
speed by turning the variable speed dial (T).
NOTICE:
operation, the speed control prevents the motor
speed from decreasing. If you expect to hear a
speed change and continue to load the motor,
you could damage the motor by overheating.
Reduce the depth of cut and/or slow the feed rate
to prevent tool damage.
The laminate trimmer is equipped with electronics
to monitor and maintain the speed of the tool
while cutting.
The speeds in this chart are approximate and are for
reference only. Your laminate trimmer may not exactly
produce the speed listed for the dial setting.
speed recommendations as some bit designs require
specific speeds for safety or performance.
If you are unsure of the proper speed or are experiencing
any type of problem, contact the bit manufacturer.
WARNING
power source before installing and removing accessories, before adjusting or
when making repairs. An accidental start-up can cause injury.
REPAIRS
For assistance with your tool, visit our website at www.portercable.com for a list of service
centers, or call the PORTER-CABLE Customer Care Center at (888) 848-5175.
In low and medium speed
SPEED SELECTION CHART
DIAL SETTING
1
2
3
4
5
6
WARNING
Always follow the bit manufacturer's
MAINTENANCE
To reduce the risk of injury, turn unit off and disconnect it from
FIG. 8
T
APPROX. RPM
16,000
19,300
21,400
23,700
26,400
30,000
12 - ENG
Publicité
