Kenwood KAC-322 Mode D'emploi page 5

CONNECTIONS
@ INSTALLATION
Power-contral lead {Blue/White}
—
. Before installation and wiring,
remove the © terminal of the
battery to prevent short-circuiting.
2. Connect the input and output
cords of the system.
. Connect the ground to the chassis
of the car.
, Connect the power supply lead
(yellow).
. Install the set and after confirming
the installation and wirings are
correct, connect the © terminal of
the battery.
ao —S &
e |f a fuse is blown, first check that
the associated wires are not short-
circuited then replace the fuse witn
a new one having the same @) Power connection cord
capacity.
Power supply lead (Yellow) ¢€
Ground tead (Black) © (T
As the unit uses BTL output, always connect
the without white stripe, gray stripe speaker
wires to the © terminals of the speaker
systems. Never let the © speaker wires
touch and never connect them to the (White stripe}
chassis (ground). De not let the speaker @
(ground).
insulate any unused output wire with vinyl
; ' (Gray stripe}
tape to prevent a short circuit.
tie