Publicité
Les langues disponibles
Les langues disponibles
GB
faces (e.g. paper, textiles).
Risk of fire due to heating
caused by charging.
•
If the power cable for this
equipment is damaged, it
must be replaced by the
manufacturer, a customer
service agent of the same or
a similarly qualified person
in order to prevent hazards.
•
Do not use the charger to
charge non-rechargeable bat-
teries.
Charging process
Do not expose the battery to
extreme conditions such as heat
and impact. There is a risk of
injury from leaking electrolyte
solution! In case of contact,
rinse with water or neutraliser
and consult a doctor if contact
has occurred with eyes etc.
Ensure that the equipment is
charged for no longer than
3-5 hours without interruption.
The battery and equipment could
be damaged and they consume
energy unnecessarily in case of
longer charging time. Overcharg-
ing invalidates the guarantee.
Charge the battery only in dry
areas.
Do not switch on the device
while charging it.
There is a risk of injury from
electric shock.
76
1.
The safety key (8) must be du-
ring the loading process plug.
2. Connect the charger cable plug
(18) with the charger socket on
the tool (7).
3. Connect the power supply unit
(17) to a socket.
The charging indicator (3) lights
up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging
time is max. 3 – 5 hours.
4. After the recharging process
is completed, first unplug the
charger from the wall outlet, and
then remove the charger cable
plug (18) from the tool.
Operation
Keep to noise abatement regula-
tions and other by-laws.
Switching on and off
1. Remove the blade guard
(12/15) before switching the unit
on.
2. Insert the safety key (8) into the
device.
3. To switch on, hold the switch
lock (4) depressed and operate
the on/off switch (9). Then re-
lease the switch lock.
The equipment runs at top
speed.
4. In order to switch off, let go of
the on/off switch (9).
Publicité
