6. USE INSTRUCTIONS
1. Take the equipment out of its packaging and assemble the base according to
the instructions.
screw
holes
assembly
1. Install the front and rear sections of the bracket first and fix them with
screws.
2. Repeat the same operation for the lateral sections.
3. Install the wheels by inserting them into the corresponding holes. The
wheels with brakes will be located at the front and those without brakes at the
rear.
2.Fill the water tank so that the water level is always between the MIN and
MAX marks.
3. Please plug the power cord with dry hands and make sure it is well connec-
ted. The equipment will enter STANDBY mode.
4. Press ON/OFF to turn on the machine. The display will show the temperatu-
re and the equipment will start to work at low speed. If you press ON/OFF
again, the equipment will return to STANDBY mode. It is convenient to turn off
the COOL mode 15 min. before turning off the equipment so that the cooling
filters can dry.
5. Press the SPEED button: the wind speed will change from low to medium,
high or strong. When starting the engine it has a delay of 5 seconds.
6. Press SLEEP to activate/deactivate SLEEP MODE.
7. Press TIMER to activate/deactivate the equipment shutdown timer between
1 and 24h.
8. Press SWING UP/DOWN or SWING LEFT/RIGHT to activate/deactivate the
automatic swing of the horizontal or vertical louvers.
9. Press the COOL button to start evaporative cooling. If you do not press
COOL, the equipment works as a fan. If the water tank is low on water, the
equipment will give an audible alarm and the COOL mode will stop.
connector
10
screw
castors
holes
castors
with brake