Peavey Messenger M100 Mode D'emploi page 23

THINK SAFETY FIRST!
Much of the setup of the Messenger ™ M100 is similar to the setup of other sound systems, and many aspects require plain
common sense. Safety should always be your first concern. Always use grounded outlets and three-wire extension cords.
Run sound system cables in a way to prevent the danger of tripping, and tape them down where necessary. Place the
speaker stands and mixer stand on a solid, level surface. Following these guidelines will help prevent personal injury and
.
equipment damage
Setting Up Mixer and Speakers
Place the unit on a horizontal surface. Release the latches by lifting up until they disengage. Open the top cover and remove
the speakers from the Messenger package.
Place speakers on a suitable surface and position them so that they will face toward the audience and away from the
microphones. All of the necessary interconnect cables can be found in the convenient zipper pouch. Connect the speaker
cables from the jack on the rear of each speaker to the powered mixer, connecting the left speaker to the LEFT OUTPUT
and the right speaker to the RIGHT OUTPUT jacks on the side panel of the unit.
Warning! Do not connect additional speakers to the Messenger powered mixer. The included speakers
provide the optimal load for the amplifier.
Quick Setup Guide
9