KOBE CH2230SQ-1 Mode D'emploi page 15

4. For Rear 3-1/4" x 10" vent installation only:
-
Remove attached 6" exhaust and discard.
(Figure 12) Keep 13 screws to install vent
covers.
-
Remove duct knockout from back of the
hood and discard. (Figure 14) Unscrew 3-
1/4" x 10" Vent Cover from rear exhaust
(located inside hood); keep screws to
install 3-1/4" x 10" Exhaust.
-
Align Top Vent Cover {E} and 3-1/4" x 10"
Vent Cover (removed from rear exhaust)
using 14 screws (13 screws taken from 6"
exhaust). (Figure 14) Follow instructions in
Step 5 to attach Hood Mounting Bracket
{K} and two Duct Cover Support {L} using
14 screws (13 screws taken from 6"
exhaust). (Figure 16)
-
Attach the 3-1/4" x 10" Exhaust {D} to rear
exhaust (located inside hood) using 10
screws taken from rear vent cover. (Figure
15)
Hood Installation
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the
power in an electric range at the
electrical box. SHUT
BEFORE MOVING A GAS RANGE. And use a
protective covering to protect cooktop and/or
countertop from damage.
5. Secure Hood-Mounting Bracket {K} and two
Duct Cover Support {L} on top of the hood with
eight pre-attached screws. Use four 3/16" x
3/8" screws {J} for Hood-Mounting Bracket {K}.
(Figure 16)
6. Using references
measurements on page 20-22, mark the
leveling point of the hood.
mounting screws (not provided) on the wall,
leaving 1/8" away from the wall as shown in
Figure 17.
7. Align Hood-Mounting Bracket {K} to the two
screws on the wall and hook hood into place.
Tighten screws to secure hood to the wall.
CAUTION
:
SECURE BEFORE RELEASING
OFF THE
on Table
Position two
MAKE SURE HOOD
Figure 14
Figure 15
main
GAS
Figure 16
2 and
Figure 17
IS
12
Mounting Screws