IBEA KRATOS 40 Manuel D'utilisation Et D'entretien page 22

Battery screen functions description
Single cells voltage
Charging the battery
It is recommended to charge new battery before the rst use of the electric pruner.
To charge the battery, ensure the battery power switch is in OFF position. Plug the
battery charger output into the battery charging jack, plug the charger into a power
socket and the switch to ON position. The LED indicator on the battery will turn RED
during charging and turn GREEN when the battery is fully charged. The battery takes
about 2 hours to obtain full charge. A fully charged battery can sustain 6-8 hours of
continuous pruning operation.
Operation
1. Connect the Pruner to the power cord (as shown in Figure 1).
2. Connect the power cord to the battery (as shown in Figure 2).
3. Put the battery on your waist.
4. Turn on the power switch.
5. Pull the trigger two times continuously and quickly to start the Pruner,
so that you can start working normally with the Pruner.
6. If the branches are small in diameter and you want to speed up the cut, set the
blades opening at 30 mm instead of 40 mm. To do this proceed as follows: keep the
trigger pressed for 2 seconds, until you hear an acoustic signal. To restore the previous
setting, repeat the procedure.
CAUTION
If the battery switch is in the ON position and you do not use the pruner or run
unloaded cuts for the duration of 10 minutes, the machine may go into
STAND-BY mode. Press the M button on the battery to turn the machine back on.
The STAND-BY function could also be activated for continuous cuts of thin branches.
The STAND-BY function is essential for safeguarding the battery in the event the
operator forgets to turn o the battery at the end of the work.
Cutting times
at present
1000 times Maintenance cycle
Total cuts
300000 times
30000 times
Figure 1
Recharge cycles
115
Figure 2
20
Battery capacity
at present
%
75
Figure 3