Publicité
Les langues disponibles
Les langues disponibles
E N
The communication frequency between the unit and the remote control has
already been preset. If you cannot use the remote control with the unit, follow
the instructions "Set up communication between the remote control and the
unit" to re-establish the connection.
R E M OT E C O N T RO L'S S TA N D BY M O D E
The screen shows the remote control's standby mode.
S W ITC H O N/O F F
Press this
button to switch the flame effect and the heater on or off. Press
this
button to switch the flame effect on or off in daily or weekly timer mode.
F L A M E E F F E C T
Press
to display the screen for adjusting the flame effect. Press the
button to select the three-level flame effect. Press the '+' and '-' buttons to
select the five levels of flame effect brightness and the OFF setting.
M O O D LI G H T
Press
to display the screen for adjusting the mood lighting. Press the
and
button to toggle through the 13 colours of the mood light or a colour
cycle mode. Press the '+' and '-' button to select the five brightness levels of
the mood light.
BAS E T R AY L E D LI G H T
Press the
button to access the screen for adjusting the LED light in the base
tray. Press the
or a colour cycle mode. Press the '+' and '-' button to select the five brightness
levels for the lighting.
N O R M A L M O D E
The normal control mode is set at the factory. If this is not the case, press the M
button until the logo
'+' and '-' buttons to adjust the setting temperature from 17 °C to 25 °C in two
intervals. Press the button
displayed at the bottom of the screen.
34
and
button to toggle through the 13 colours of the LED light
is displayed in the upper corner of the screen. Press the
to switch the heater on and off. ON and OFF are
and
Publicité
