Brady HSB1500 Manuel De L'utilisateur page 9

HOW TO CORRECT PROBLEMS IN THE MACHINE
Problem
The machine will not run.
The machine will not start.
The brush warning light illuminates.
The machine is vibrating excessively.
Operator's Manual (EN) - High Speed Burnisher
Cause
The machine may not have any power.
The power cord may be damaged.
The pad is worn or dirty.
The machine may have no power.
The carbon brushes need replacing.
The pad is not installed correctly.
The pad is worn or damaged.
The pad is defective.
ENGLISH
Action
Make sure the machine is connected to the
correct voltage and frequency and that all
connections are tight or,
Make sure the machine is plugged in.
Contact an authorized service person
Clean the pad. If the pad is worn, replace it.
Make sure the machine is connected to the
correct voltage and frequency and that all
connections are tight or,
Make sure the machine is plugged in.
Contact an authorized service person.
Remove the pad. Install the pad correctly.
Center the pad properly.
Install a new pad.
Inspect and install a new pad.
FORM NO. 56091093 - 9 -
EN