DURAVIT Starck S1 9720 Notice De Montage page 6

1
Ø ⅜"
2x
NOTICE
A 110 V GFCI outlet is
required.
> Mark the holes to be
drilled for the anchors.
5
> Lift the mirror backing
up and onto the mountain
brackets.
> Check the mirror backing
is leveled.
9
1x
> Screw the bolt to the wall
at the specified location.
> For wood stud walls, bolts
should be screwed into
wood backing.
2
> Use a 3/8" drill bit.
> Drill the anchor holes that
have been marked.
6
> The top screw will adjust
closer and further.
> From the mirror, the lower
screw will adjust up and
down.
10
1
2
1
> Plug the unit into the
outlet.
> Plug the cords (1) into
control unit.
> Slide the unit onto the
mirror backing.
3
> Detach mirror front with
four screws.
7
> Mark the hole to be
drilled.
> Remove mirror backing.
11
2x
> Attach mirror front to
mirror backing with two
top supplied screws.
4
2
1
> Lift the mirror up.
> Slide the mirror backing.
8
Ø ⅜"
1x
> Use 3/8" drill bit.
> Drill the anchor hole that
has been marked.
> The plastic anchor
provided is for concrete
wall application.
12
2x
> Attach mirror front to
backing with two bottom
supplied screws.
MAL_Starck_S19720/17.11.1
6