Télécharger Imprimer la page

BOERPLAY Boracay Instructions D'installation page 27

Publicité

Installation:
1. Pull the piston rod out of the gray cylinder
and pull the tie rod out of the blue riser on
the male side. Connect the tie rod of the first
riser to the piston rod of the pump cylinder
and tighten securely using the two open-end
wrenches. Slide the protection hose out of
the riser pipe as far as possible over the
piston rod.
2. Connect the pump cylinder to the riser by
twisting the blue tube into the cylinder.
Be careful not to damage the thread, feel
gently until the thread catches. Then tighten
the tube firmly, hand tight is sufficient.
3. Lower the cylinder and riser combination
into the well / water storage. The black
cylinder is the first to enter the well! Let the
pump pipe protrude approximately 1 meter
above the borehole and hold or clamp it.
4. Depending on the depth of the source /
water storage, one or more risers are now
attached to each other to reach the depth.
Use the string for this. Pull this through the
empty riser, make sure that the loop
protrudes from the side with external thread.
Place the pipe with string next to the
borehole / water storage. While one holds the
riser tightly, the other connects the next tie
rod to the one sticking out of the blue pipe.
Slide the protective hose over the connecting
nut as far as possible and gently lower the
drawbar into the riser. Secure the loop of the
string to the connecting nut. Slide the riser
with string over the pump rod and screw it
onto the riser protruding from the borehole.
Let it all sink into the well. Use the string to
pull the drawbar back out of the riser and
repeat the above until the desired depth is
reached.
Assembly manual for Hand pump HPOl
0
BOER
PLAY
2 of 4

Publicité

loading

Ce manuel est également adapté pour:

Pste800.001