Pioneer SGY-PM910V Mode D'emploi page 20

EN
Switch to dual power meter mode
4. Switch the sensor mode.
LED
• Before switching the mode, confirm
that there is no other pedaling
monitor near by. If this is not done at
a sufficient distance away from other
sensors, the other sensors are likely
to malfunction.
20
Water-proof
packing
Push switch
Push for more than
3 seconds
The LEDs blink green
Move away
The LEDs blink orange
rapidly
Confirm that the LEDs
on left and right
transmitters are blinking
Push for more than
3 seconds
Finished
The LEDs light orange
Failure
The LEDs blink red