Signature BO7202 Manuel D'utilisation page 35

KNOW YOUR KETTLE
Body
Water gauge
Decorative ring
OPERATION
Before initial use
If you are using the kettle for the first time, it is recommended that you
clean your kettle before use by boiling a full kettle of water twice and
then discarding the water.
1. To fill water into the kettle, remove it from the power base and
open the lid by lifting the lid button, fill with the desired amount of
water to the kettle. Always fill the kettle between the minimum (0.5L)
and maximum (1.5L.) marks. Too little water will result in the kettle
switching off before the water has boiled.
NOTE: Do not fill the water over the maximum level, as water may
spill out of the spout when boiling. Ensure that the lid is firmly in
place before connecting the power cord to the outlet.
2. Close the lid. Position the kettle on the power base in place. Make
sure the kettle contact with the power base completely.
3. Connect the plug into a power outlet. Press down the switch to "I"
position and the switch light illuminates. Then start to boil the water.
The kettle will switch off automatically once the water has boiled and
the switch light extinguishes. You can shut off the power by pressing
the switch at any moment during boiling water.
NOTE Ensure that switch is clear of obstructions and the lid is firmly
closed. The kettle will not turn off if the switch is constrained or if the lid
- 3 2 -
Lid
Lid back
Lid button
Handle
Switch
Base