Create MILL PRO Manuel D'utilisation page 7

• Never immerse the cable, plug, or main body in water or other
liquids. If the appliance should fall into water, immediately
unplug it from the mains and have it checked by an expert
before using it again. It may cause fire, electric shock, injury
or death.
• The blades are very sharp. Always be very careful.
• Never leave the appliance unattended during operation.
• Do not lift or operate the appliance if the power cable or plug
is damaged, or if the appliance is malfunctioning or has been
dropped or damaged in any way. In case of damage, please
contact the after-sales service. A damaged cable or plug
must only be replaced by the manufacturer or a qualified
person to avoid injury.
• Use only accessories recommended by the manufacturer.
• Do not let the cable hang over the edge of a table or coun-
tertop. Do not operate the appliance near hot surfaces, avoid
proximity to open fires and all sources of heat and ignition.
• The maximum capacity is 40g. Do not use the appliance for
more than 1 minute at a time. Then wait 10 minutes to allow
the motor to cool down.
• Do not process more than three batches immediately after
one another. Allow the unit to cool down to room temperature
before proceeding.
E N G L ISH
7