Publicité
Les langues disponibles
Les langues disponibles
BM 2610933664 7-05
REMOVING AND INSTALLING
DUST CANISTER
To remove dust canister: squeeze release
tabs on both sides of canister and simply pull
away from the tool.
To install dust canister: align dust port with
hole in canister and push canister onto tool
until it locks into place.
CLEANING AND EMPTYING THE
DUST CANISTER
To empty canister, hold canister and
maintain a firm grip. Firmly push upward on
tab on corner of lid, and remove from
canister. Knock excess dust out of the
microfilter, or remove dust with your fingers
or a soft brush. You may notice that all the
dust may not come out of the canister. This
will not affect sanding performance but will
reduce dust collection efficiency.
NOTE: Do not wash the micro filter with soap
and water. Dust may become more firmly
lodged in the pores, which will reduce dust
collection, and damage the micro filter.
SANDING: open-coat aluminum oxide sanding
discs are recommended for most wood or
metal sanding applications, as this synthetic
material cuts quickly and wears well. Some
applications, such as plastics, glass, or stone
require silicon carbide discs, which have a very
sharp cutting edge. For best results, use
Klingspor sanding and polishing accessories
which are of superior quality and are carefully
selected to produce professional quality results
with your sander.
With the workpiece firmly secured, depress
switch while applying the pad to the work
surface. DO NOT apply excessive pressure as
this will slow the pad action, and DO NOT start
the tool and bring it up to speed before
applying to the work; swirl marks will result in
either case. In general, higher speeds and
moderate pressure will give the best results. If
faster removal is desired, DO NOT INCREASE
PRESSURE ON THE TOOL; use a coarser
grade of abrasive. Move the sander in long
sweeping strokes, parallel to the grain using
some lateral motion to overlap the strokes by
7/28/05
3:37 PM
"Tool Tips"
Page 9
ATTACHING VACUUM HOSE
When the canister is removed from the tool,
an (optional) vacuum hose accessory can be
attached to the dust port. To use this feature,
attach vacuum adapter(s) and vacuum hose
(optional accessories) to dust port, then
connect opposite end of the vacuum hose to
a shop vacuum cleaner.
19MM
HOSE
as much as 75%. The random orbit action
allows cross-grain sanding, but be careful not
to tilt the sander near edges, or undesirable
rounding may result.
If the surface is rough, begin with coarser grits
and then complete the surfacing with medium
and fine abrasives. Because the random orbit
action is so effective, it is often possible to
begin sanding with a medium grit disc and go
directly to fine finishing. To avoid uneven
results, do not skip more than one grit size
when going from coarser to finer, and do not
sand in one area for too long. When the job is
completed, release switch, and gently lift the
tool from the work surface at the same time.
POLISHING:
for most polishing, the soft
backing pad will give the best results. The
random orbit sander may be fitted with a foam
buffing pad or polishing bonnet to polish or
remove scratches from painted or finished
surfaces, plastics, and even glass. The tool is
operated in much the same way as when
sanding, but the following points should be
observed;
-9-
1-1/4"
OR
1-1/2"
HOSE
Publicité
