Publicité
Les langues disponibles
Les langues disponibles
Always wear SAFETY GLASSES
when installing hitch
Authorized Drawbar Kit:
36071 (Sold Separately)
Drawbar must be used in the
RISE position only.
①②
Figure 2
1.
Clean weldnuts: Remove the sticker covering on the (2) weldnuts on the side of frame rails, both sides, see Figure 2. Use a M12x1.25 tap to clean the weldnuts.
2.
Lower exhaust muffler: Using exhaust removal pliers, remove rubber hangers at (3) locations. Be sure to support exhaust before removing rubber hangers.
3.
Install hitch: Raise the hitch into position and slide the brackets above the exhaust pipe. Align bracket holes to the frame rail weldnuts and loosely install M12 bolts ① and conical
washers ② to the hitch, see Figure 1. Due to narrow space around passenger side frame rails, use 19 mm crowfoot wrench to secure the M12 bolts on passenger side.
4.
Tighten all M12 fastners with torque wrench to 76 Ft.Lb. (103 N*M)
5.
Reinstall the rubber hangers and exhaust muffler.
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for
connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2019, 2022 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 36675, 06192, CQT36675
Frame rails
Figure 1
Sheet 3 of 18
36675NP
Fastener Kit: 36675F
①
Qty. (4)
Bolt M12x1.25x30
CL8.8
②
Qty. (4)
Conical washer 1/2''
Part #: 01292008
Fasteners
Conical washer
typical
teeth side
both sides
against hitch
06-15-22
Rev. B
Publicité
