Publicité
PROBLEM
POSSIBLE CAUSE
Not plugged in.
The light
The circuit breaker
does not
tripped or a blown fuse.
work.
The light button is
"OFF".
The cooler is not leveled.
The bottles are
Vibrations.
vibrating.
There is an object under
the cooler.
The cooler is not level.
The cooler
seems to
make too
much
Normal noise from the
noise.
flow of the refrigerant
14
SOLUTION
Plug the cooler in.
Check the breaker
and/or fuses.
Press
to turn the
light ON.
Check to assure that the
cooler is level.
Make sure the bottles
don't touch each others.
Remove the object
under the cooler.
Level the cooler.
The rattling noise may
come from the flow of
the refrigerant, which is
normal. As each cycle
ends, you may hear
gurgling sounds caused
by the flow of refrigerant
in your cooler.
Contraction and
expansion of the inside
walls may cause popping
and crackling noises.
The cooler is not level.
The door was reversed
and not properly
installed.
The door will
not close
properly.
The gasket is dirty.
The shelves are out of
position.
This is normal during
high humidity periods.
This is normal in
Moisture
high temperature
builds up on
environment.
interior or
exterior of
the Beverage
Prolonged or
cooler.
frequent door
openings.
The door does not seal
completely.
Error Code:
A sensor has failed.
E1-E2-E3-E4-
E7-E8
Level the cooler.
Re-install the door
properly.
Clean the door gasket.
Place the shelves properly.
Lower the room humidity.
Move the cooler to a
cooler place, and avoid
heat and sunlight.
Less to open the door.
Check door gaskets for
proper seal.
Contact the qualified
technician.
15
Publicité
