RAB Design XFL3-LED Instructions D'installation

XFL3/4/5-LED
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY
•
Proper grounding is required to ensure personal safety.
•
Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.
•
Do not use this equipment for anything other than its intended purpose.
•
Servicing this equipment should be performed by qualified service personnel.
•
Save these instructions.
•
MIN 75 °C SUPPLY CONDUCTOR
INSTALLATION
Slip Fitter:
1. Slip Fitter is installed as standard on this fixture.
2. Loosen the adjusting bolt, align the fixture to required angle. Tighten
adjusting bolt after the angle is confirmed.
Note: Adjustable angle is 180°.
Yoke:
1. Remove slip fitter bracket and mounting screws on the fixture as shown.
[2][3]
2. Install the yoke on the fixture as shown. [4][5][6]
3. Make the wiring connections as per diagram below. Install the yoke onto
chosen mounting location.
4. Loosen the adjusting bolts, align the fixture to required angle. Tighten
adjusting bolts after the angle is confirmed.[7][8]
Note: Adjustable angle is 180°.
[4]
RAB Design Lighting inc.
READ, UNDERSTAND
before installing the equipment.
[5]
August– 2023
FOLLOW
, and these instructions
Adjusting
bolt
[1]
[2]
[6]
Page 1 of 5
[3]