Pfister CONTEMPRA LF 49 Serie Manuel D'installation page 3

Les langues disponibles

7 HANDLE INSTALLATION

Thread Valve Adapters (7A) onto the Valve End Bodies (7B) and tighten so that the

Valve Adapters (7A) sit on the surface of the Valve Body Washers (7C). Place Plastic

Seal Rings (7D) against the bottom of Handle Hubs (7E). Connect Handles (7F) onto

Valve Adapters (7A).

Be sure Valves and Levers are in the "OFF" position. Secure handles by holding the

Lever (7G) in place and tighten Handle Hubs (7E) by rotating them in a clockwise

direction. To remove handles, rotate Handle Hubs (7E) in a counterclockwise direction.

ENGLISH

8 SPOUT INSTALLATION

Insert Lift Rod (8A) into hole at the back of Spout (8B). Place Plastic Seal Ring (8C)

against the bottom of Spout Body (8D). With Spout (8E) facing forward, carefully install

the Lift Rod (8A), Shank (8F) and receiving Tube (8G) through the center hole of sink (8H).

9 SECURING FAUCET

From underneath sink, secure the faucet by placing the Metal Washer (9A) and the Long

Nut (9B) ( 7 / 16 hex.) onto the Mounting Post (9C). Make sure that the bumps on the

Metal Washer (9A) are facing up. Tighten using a Slotted screwdriver or an adjustable

wrench until the faucet is firmly connected to the sink.

Do not over tighten!