Publicité
Les langues disponibles
Les langues disponibles
NOTE:
Production residue or dust may have collected on the
appliance. We recommend cleaning the appliance
"Cleaning and Maintenance"
according to chapter
Appliance Equipment
Appliance overview
1 Lighting
2 Bottle racks
3 Control panel
4 Door handle
Delivery scope
2x bottle rack, 1x door handle incl. mounting material
Installation
Conditions for the installation location
Good ventilation is required around the appliance
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Gap to the back approx. 50～70 mm, to the
-
side walls and above the device each approx.
min. 100 mm;
Place the appliance so that the appliance door
-
can open without being impeded.
Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
5 Unit housing
6 Condensation collection
tray
7 Feet
The climate class can be found under
Data"
and on the rating label located in the interior
or on the appliance rear.
.
Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Assembly of the door handle
Open the appliance door and slightly remove the
door rubber seal on the inner door frame. Note
the holes underneath for the positioning of the
door handle.
Fasten the handle with the enclosed screws incl.
washers and bring the door rubber seal back to its
original position.
34
"Technical
1 Door rubber seal
2 Door frame
3 Door handle
4 Screws incl. washers
Publicité
